Suckless Termial with personal patch
https://st.suckless.org
ac8f05c45a
Add the documentation from the vt100 manual programmer: Control Octal Action Taken Character Code ------------------------------------------- NUL 000 Ignored on input (not stored in input buffer; see full duplex protocol). ENQ 005 Transmit answerback message. BEL 007 Sound bell tone from keyboard. BS 010 Move the cursor to the left one character position, unless it is at the left margin, in which case no action occurs. HT 011 Move the cursor to the next tab stop, or to the right margin if no further tab stops are present on the line. LF 012 This code causes a line feed or a new line operation. (See new line mode). VT 013 Interpreted as LF. FF 014 Interpreted as LF. CR 015 Move cursor to the left margin on the current line. SO 016 Invoke G1 character set, as designated by SCS control sequence. SI 017 Select G0 character set, as selected by ESC ( sequence. XON 021 Causes terminal to resume transmission. XOFF 023 Causes terminal to stop transmitted all codes except XOFF and XON. CAN 030 If sent during a control sequence, the sequence is immediately terminated and not executed. It also causes the error character to be displayed. SUB 032 Interpreted as CAN. ESC 033 Invokes a control sequence. DEL 177 Ignored on input (not stored in input buffer). -------------------------------------------- --- st.c | 28 +++++++++++++++++++--------- 1 file changed, 19 insertions(+), 9 deletions(-) |
||
|---|---|---|
| .hgtags | ||
| config.def.h | ||
| config.mk | ||
| LEGACY | ||
| LICENSE | ||
| Makefile | ||
| README | ||
| st.1 | ||
| st.c | ||
| st.info | ||
| TODO | ||
st - simple terminal
--------------------
st is a simple virtual terminal emulator for X which sucks less.
Requirements
------------
In order to build st you need the Xlib header files.
Installation
------------
Edit config.mk to match your local setup (st is installed into
the /usr/local namespace by default).
Afterwards enter the following command to build and install st (if
necessary as root):
make clean install
Running st
----------
If you don't install st, define TNAME to "xterm" in config.h or make sure to at
least compile st terminfo entry with the following command:
tic -s st.info
It should print the path of the compiled terminfo entry. You can
safely remove it if you don't plan to use st anymore.
See the man page for additional details.
Credits
-------
Based on Aurélien APTEL <aurelien dot aptel at gmail dot com> bt source code.